CONTACT US

How can I communicate with my dehydrator?

by | Jul 26, 2017 | NETCOM FAQs

The NETCOM dehydrator can communicate via Ethernet, RS422, and RS232. The Ethernet interface provides the best communications and control of the dehydrator by providing a web based interface. Through this interface, you can monitor the system, change the IP address,...

Can I change the IP address ?

by | Jul 26, 2017 | NETCOM FAQs

Yes, Establish communications with the dehydrator through the Ethernet interface (default IP address from the factory is 192.168.52.9) and navigate to the configuration page. Here you can change the IP address by either allowing the unit to “obtain IP address...

Can I link two dehydrators together?

by | Jul 26, 2017 | NETCOM FAQs

By default, a NETCOM is set as a slave so that it will accept commands from any other NETCOM dehydrators that has been configured as a master. To configure a NETCOM as a master establish communications with the dehydrator through the Ethernet interface (default IP...

How can I communicate with my ASM-1 Smart Manifold?

by | Jul 26, 2017 | ASM-1 FAQs

The ASM-1 Smart Manifold can communicate via Ethernet, RS422 and RS232. The Ethernet interface provides the best communications and control of the dehydrator by providing a web based interface. Through this interface, you can monitor the system, change the IP address,...

How do I setup my ASM-1 Smart Manifold?

by | Jul 26, 2017 | ASM-1 FAQs

The setup of the ASM-1 smart manifold can be done with the following steps: Set up the IP configurations for the Netcom’s and the smart manifold (configuration page) Set up the pressure parameters on the Netcom’s and set them for large system operation Netcom...