by ETI Staff | Jul 26, 2017 | NETCOM FAQs
The NETCOM dehydrator can communicate via Ethernet, RS422, and RS232. The Ethernet interface provides the best communications and control of the dehydrator by providing a web based interface. Through this interface, you can monitor the system, change the IP address,...
by ETI Staff | Jul 26, 2017 | NETCOM FAQs
Yes, Establish communications with the dehydrator through the Ethernet interface (default IP address from the factory is 192.168.52.9) and navigate to the configuration page. Here you can change the IP address by either allowing the unit to “obtain IP address...
by ETI Staff | Jul 26, 2017 | NETCOM FAQs
By default, a NETCOM is set as a slave so that it will accept commands from any other NETCOM dehydrators that has been configured as a master. To configure a NETCOM as a master establish communications with the dehydrator through the Ethernet interface (default IP...
by ETI Staff | Jul 26, 2017 | NETCOM FAQs
I have an alarm code displayed in my status window, what does it mean? The ADH NETCOM will display an alarm code when it detects an error, or parameter outside the set range.There are numerous alarm codes associated with different issues that could arise with the...
by ETI Staff | Jul 26, 2017 | NETCOM FAQs
Short cycling of the compressor may be caused by a leak in the pressure system. It could be a leak in the waveguide system, in the dehydrator or in the interconnecting tubing. To determine which area of the system is leaking, disconnect the dehydrator from the...
by ETI Staff | Jul 26, 2017 | NETCOM FAQs
Software updates appear on this website under the Support pulldown under Software. Click here to go to the Software page. Below are the steps and warnings for updating the ADH Netcom Waveguide Dehydrator and ASM-1 Smart Manifold. Instructions Navigate to our...