by ETI Staff | Jul 26, 2017 | Passive Dehydrators FAQs
Both the RCD-1 and the RCD-2 passive dehydrators are bottles filled with desiccant, the RCD-1 with no moving parts, uses gas diffusion to dry the waveguide while the RCD-2 uses its one moving part (a check valve), temperature changes and barometric pressure to move...
by ETI Staff | Jul 26, 2017 | ASM-1 FAQs
The ASM-1 Smart Manifold can communicate via Ethernet, RS422 and RS232. The Ethernet interface provides the best communications and control of the dehydrator by providing a web based interface. Through this interface, you can monitor the system, change the IP address,...
by ETI Staff | Jul 26, 2017 | ASM-1 FAQs
The setup of the ASM-1 smart manifold can be done with the following steps: Set up the IP configurations for the Netcom’s and the smart manifold (configuration page) Set up the pressure parameters on the Netcom’s and set them for large system operation Netcom...
by ETI Staff | Jul 26, 2017 | ASM-1 FAQs
Actually, there isn’t a plug in port number 8, it is a bleed. If you examine it very closely you will notice that there is a small hole in the middle of it. This is used by the Smart Manifold to bleed off pressure if it senses that it is too high and during its...
by ETI Staff | Jul 26, 2017 | ASM-1 FAQs
Yes, but then you will need to set the unit’s port as an input with no IP address. The Smart Manifold will monitor it but will have no control over ADH-2ACom or ADH-3Com other than to be able to open and shut its output through the...
