by ETI Staff | Jul 26, 2017 | APS-C Series FAQs
APS-4C to SC-40C connections are done on the Class 2 terminal blocks on both units as follows. APS-4C Pin SC-40C Pin Next SC-40C Pin 4———————4————————–4...
by ETI Staff | Jul 26, 2017 | APS-C Series FAQs
This indicates that there is a ground fault on one of the attached SC-40C satellite controllers. The SC-40C that has the ground fault will have a solid red GFEP light and will not allow the heaters to be powered. Isolating the heater leg that has the ground fault is...
by ETI Staff | Jul 26, 2017 | APS-C Series FAQs
EMC stands for Energy Management Computer, which can be used to remotely monitor and control the APS-C series ice melt controllers. These connections are made to the Class 2 connection terminal block on pins 14 through 22. The following diagram will aid in making...
by ETI Staff | Jul 26, 2017 | APS-C Series FAQs
Why doesn’t adjusting the High Temperature Limit dial turn the unit on? The High Temperature limit dial is used to set the maximum temperature that the unit will work at. When the High Temperature limit sensor detects a temperature higher than what is selected on the...