• Home
• Products
• News
• Newsletters
• Press Releases
• Support
• Instruction Manuals
• Obsolete Products
• Design Aids
• White Papers
• Application Notes
• MIB Files for SNMP
• Software/Firmware
• Contact us
• Employment Opportunities
• Telecommunications

ADH NETCOM 8-2-3

8-2-3 (2009-11-20): This software version adds an internal initialization of the alarm relay contacts to fix a false alarm condition that may occur on start up.This update includes all previous updates.

After installing this update the main page should display:

Main Firmware: NCTEST8-2-3
Comm Firmware: NCTEST8R-1-4

Files included:

• nc8cfg.htm (nc8cfg14.htm in the zip file): nc8cfg14.htm will be renamed to nc8cfg.htm during install.
• nct8-1.c12
• nct8-2.c12
• nct8-6.c12

Download: fw823.zip 180 kb 10/7/2009

Installation Instructions

1. Download fw823.zip and save it to you local drive, thumb drive, or similar media.
2. Uncompress the contents of the zip file.
3. Open a web browser and go to http://[your_ip_address]/nc1cntl.htm. If you can not get the page to open be sure that your computer is in the same subnet as the ADH NETCOM.
4. Click "Enable firmware downloads."
5. Using the windows command line:
   • change directories to the location you uncompressed the files to in step 2.
   • type -> tftp -i 192.168.52.9 put nct8-1.c12 1!
   • Hit return and wait for the command to complete.
   • type -> tftp -i 192.168.52.9 put nct8-2.c12 2!
   • Hit return and wait for the command to complete.
   • type -> tftp -i 192.168.52.9 put nct8-6.c12 6!
   • Hit return and wait for the command to complete.
6. Return to your web browser and page http://[your_ip_address]/nc1cntl.htm.
7. Click "Activate firmware download."
8. After the firmware has been installed and verified the lights on the front of the ADH NETCOM will blink alternately until the reset process is complete.
9. Using the windows command line:
   • type -> tftp -i 192.168.52.9 put nc8cfg14.htm nc8cfg.htm
   • Hit return and wait for the command to complete.
10. Return to your web browser and go to page http://[your_ip_address]/nc1cntl.htm.
11. Click "Save to flash."
12. Go to page http://[your_ip_address]/nc8cfg.htm.
13. Scroll down to the IP Configuration section.
14. Click "Fetch" to load the current IP config.
15. Enter the static IP, subnet mask and default gateway for you ADH NETCOM.
16. Click "Submit". This should return the message "I command done."
17. Click "Reset NETCOM" at the top of the page.
18. Once the ADH NETCOM has restarted return to page http://[your_ip_address]/nc8cfg.htm.
19. Scroll down to the IP Configuration section.
20. Click "Fetch" to load the current IP config.
21. Verify that the IP address, subnet mask and default gateway match what is reported by "Active Configuration."