ADH NETCOM 8R-1-4
This software is no longer the most current revision. Please refer to the software index for the most current released revision.
8R-1-4 (2009-10-07): This software version addresses the problem with units which were having issues communicating via the web interface across different network segments. The ability to add a default gateway has been added to resolve this issue.
After installing this update the main page should display:
Main Firmware: NCTEST8-2-1
Comm Firmware: NCTEST8R-1-4
Files included:
- nc8cfg.htm (nc8cfg14.htm in the zip file): The configuration web page. The IP config has been modified to allow setting of default gateway. Also added "Active Configuration" listing. When the IP config is changed and the NETCOM is reset the "Active Configuration" should match that report by an IP config "Fetch". nc8cfg14.htm will be renamed to nc8cfg.htm during install.
- nctest8r.crp: This is the firmware. It allows the IP config to set a default gateway. It also fixes a related issue where the NETCOM would save a default gateway to the parameter list but it was not being copied to the route table.
This software is no longer the most current revision. Please refer to the software index for the most current released revision.
Download: 8R-1-4.zip 180 kb 10/7/2009
Installation Instructions
- Download 8R-1-4.zip and save it to you local drive, thumb drive, or similar media.
- Uncompress the contents of the zip file.
- Open a web browser and go to http://[your_ip_address]/nc1cntl.htm. If you can not get the page to open be sure that your computer is in the same subnet as the ADH NETCOM.
- Click "Enable firmware downloads."
- Using the windows command line:
- change directories to the location you uncompressed the files to in step 2.
- type -> tftp -i 192.168.52.9 put nctest8r.crp 2!
- Hit return and wait for the command to complete.
- Return to your web browser and page http://[your_ip_address]/nc1cntl.htm.
- Click "Activate firmware download."
- After the firmware has been installed and verified the lights on the front of the ADH NETCOM will blink alternately until the reset process is complete.
- Using the windows command line:
- type -> tftp -i 192.168.52.9 put nc8cfg14.htm nc8cfg.htm
- Hit return and wait for the command to complete.
- Return to your web browser and go to page http://[your_ip_address]/nc1cntl.htm.
- Click "Save to flash."
- Go to page http://[your_ip_address]/nc8cfg.htm.
- Scroll down to the IP Configuration section.
- Click "Fetch" to load the current IP config.
- Enter the static IP, subnet mask and default gateway for you ADH NETCOM.
- Click "Submit". This should return the message "I command done."
- Click "Reset NETCOM" at the top of the page.
- Once the ADH NETCOM has restarted return to page http://[your_ip_address]/nc8cfg.htm.
- Scroll down to the IP Configuration section.
- Click "Fetch" to load the current IP config.
- Verify that the IP address, subnet mask and default gateway match what is reported by "Active Configuration."